Work with us
Mostly Cloudy,82°
Thursday, May 26, 2016
Letter to the Editor
Village shouldn’t rubber-stamp Gibson proposal

To the Editor:

In last week’s story “Developer proposes apartments; village still pursuing eminent domain,” I was pleased to read what Mayor Ed Fare said that despite the new proposal, he still wants the hearing to go forward. “We want to consider all options,” he said. “The residents of Gibson have suffered enough. We’re trying to consider all factors, make sure no stone is unturned.” 

Obviously the owner of the Gibson Boulevard buildings willfully dilapidated the property, so that everyone would think anything would be better, so that most or all would approve of anything else. The Board of Zoning Appeals granted unsafe variances just to suit the owner’s greed of creating a building in excess of the village code of 23 units based upon the amount of the square footage of the property, all the way up to 39 units. Now I read that Peter Florey, of the D&F Development Group,wants to keep the same footprint with some aesthetic changes, and raise the building up one story higher, from three to four. I have lived directly across the street for 59 years. I remember the one-story stores burning down on two different occasions, with flames threatening to destroy the residential homes across the street, and smoke coming through our windows. Being a severe asthmatic with only 30 percent lung capacity, I suffered from living across the street.

I do not want to imagine a gas explosion or fires raging through a massive four-story building now. Also, all of the other apartment buildings in the area, for example on nearby Dubois Avenue, have more than 20-foot front and rear setbacks, which would better protect residential homes. The variances granted by the BZA allow for hardly any setback at all, almost up to the curb, with trees between the building and street, which not only did not make sense, but if actually built according to that footprint, would be very unsafe.


No comments on this story | Please log in to comment by clicking here
Please log in or register to add your comment
Terms of Use | Advertising | Careers | Contact Us | Community Links © 2016 Richner Communications, Inc.